A construction equipment supplier of construction machinery solutions for 25 years.
Language
A construction equipment supplier of construction machinery solutions for 25 years.
Typical uses of the concrete vibrator are on the bridge, harbor, large dam, high-rise, and water wheel construction sites, where the vibrator is utilized to ensure an evenly-
poured, bubble-free concrete foundation or wall. The electric concrete vibrator is commonly seen in various large-, medium-, or small-sized construction projects. It
increases concrete density.
thus improving bonding strength. It also eliminates cracks, giving the concrete high water-tightness. The vibrator is an concrete vibrating tools to ensure the quality and
strength of the whole concrete construction
1.The ZID Series high frequency concrete vibrator is an immersion type vibrator. During operation, the vibrating poker that is attached to the vibrator has to be immersed into the concrete. The poker has an eccentric vibrating element inside it.
2. The vibrator incorporates off-centered weights into the 18000rpm electric motor to generate high frequency vibration. Via the flexible tube,the vibrator transmits the vibration to the poker via the flexible tube. It is spun as much as 12000 times per minute, which makes it easy to cause resonance with the poured concrete.
3. The lightweight vibrator only weights to 5.2kgs to 6kgs, giving ease of operation. It is one of the most widely used products, know for its low noise,energy efficiency, reliable functioning,high safety, and good vibrating performance.
Type | Dingo type |
Model | ZID--230D |
Rated input power | 2300W |
Rated voltage | 220V |
Rated Frequency | 50HZ |
No-load speed | 18000 r/min |
Weight | 6 kgs |
Packing size | 35*25*24cm |
Price (USD) | 115.00 |
Item | High-frequency vibrator shaft | |||
Model | (mm) | ZX-35 | ZX-38 | ZX-45 |
Diameter of head | (mm) | 35 | 38 | 45 |
Length of head | L (mm) | 330 | 370 | 390 |
Vibrating Frequency | (HZ) | 200 | 200 | 200 |
Vibrating Ampitude | (mm) | 0.91 | 1.2 | 1.2 |
Diameter of flexiable hose | D(mm) | 30 | 30 | 30 |
Diameter of flexiable shaft | D(mm) | 10 | 10 | 10 |
Price for 4mtr | (USD) | 27.14 | 32.81 | 34.43 |
Price for 5mtr | (USD) | 31.19 | 36.86 | 38.48 |
Price for 6mtr | (USD) | 35.24 | 40.91 | 42.53 |
packing size | cm | 75*75*5.5cm | ||
Handles designed to protect the perimeter against knocks.
Housing with 5 times greater resistance than required by regulation
Foam and grating filter at air intake
1. Do not leave the vibrating poker operating in the air as it will be overheated. The poker is only effectively cooled when it is immersed into the concrete.
2. Do not stop the vibrator motor whilst the poker is immersed as withdrawing will be difficult.
3. Do not lubricate the internal poker.
4. Clean the poker at 50-hour use interval.
5. Hit the poker head against the ground to start vibrating motion.
6. Hold the poker by the rubber sleeve that is wrapped around it in case excessive bending of the flexible tube occurs. Excess bend causes friction and makes the flexible tube more likely to overheat. Therefore, always keep the flexible tube as straight as possible when operating.
7. To stop the engine, turn off the ignition and cut off the petrol supply.
8. Be sure that the poker is fully immersed into the concrete.
9. The poker and flexible tube of the concrete vibrator should be maintained and cleaned with petrol every 100 hours of use.
Contact Us
Take advantage of our unrivaled knowledge and experience, we offer you the best customization service.
Get In Touch With US
If you have more questionswrite to us, tell us your requirements, we can do more than you can imagine
Recommended
+86-18968212829
